看词语>英语词典>slaking翻译和用法

slaking

英 [ˈsleɪkɪŋ]

美 [ˈsleɪkɪŋ]

v.  缓和(口渴); 解(渴); 满足(欲望)
slake的现在分词

柯林斯词典

  • VERB 解(渴)
    If youslakeyour thirst, you drink something that stops you being thirsty.
    1. I slaked my thirst with three cans of Coke.
      我喝了 3 罐可乐解渴。

双语例句

  • Objective: to approach the effect of kidney-stone slaking tablets on experimental kidney stone of rats.
    目的:探讨肾石消片对大鼠肾结石的作用。
  • The results showed that Ca ( OH) 2 saturated solution could inhibit red sandstone slaking most effectively.
    结果表明Ca(OH)2饱和液对I类红砂岩的崩解性抑制作用最强。
  • Current research on the slaking mechanism of red bed soft rock is not sufficient.
    鉴于目前国内外对红层软岩的崩解机理研究还不充分。
  • The hydration process of lime has important influence on lime slaking rate 、 particle size and specific surface, so it is significant to research the hydration process.
    生石灰的消化工艺无论是对消化产物的粒径、比表面积和孔隙率还是含水率都有很大的影响,因此有必要进行实验研究。
  • Further slaking tests were conducted by taking slaking solution which leaches out from red sand mixed with cement or lime, obtained the treatment countermeasures to inhibit red sandstone slaking by mixing with lime.
    进一步将掺水泥、石灰的改良红砂土浸出液作为水解液进行崩解试验,得到了可采用掺石灰对红砂岩的崩解性进行抑制的工程处治对策。
  • Research on Increasing the Lime Slaking
    提高石灰消和度的研究
  • The slaked area was related to the loess density, small density of subgrade loess resulted in large slaking scope.
    比较大的湿软区域易导致路基路面病害。
  • Factors Influencing the Slaking of Expansive Soil ( Rock) and Methods to Reduce Slaking
    膨胀土(岩)湿化性的影响因素及降低湿化性的途径和方法
  • Applying the grey correlation methods, this paper analyzed the correlation of slaking durability and granularity fractal characteristics of red bed weak rock as well as the experimental data of mineral and chemical component.
    采用灰色关联度法对红层软岩的粒度分形特征以及矿物、化学成分试验数据与其崩解性进行了关联分析。
  • The gelling process of HPAM/ Cr3+ microgel system in static state and shearing state was compared. The effect of rate of shearing, polymer concentration, temperature and time of slaking of solution to the gelling of microgel were studied.
    对HPAM/Cr3+微凝胶体系在静态和剪切状态下成胶过程进行了对比,并且考察了剪切速率、聚合物浓度、温度及聚合物溶液熟化时间对微凝胶成胶的影响。